Subject	Should had this discussion before the 60k, but...
Posted by	DanZMan (SF bay) on December 03, 2001 at 8:01 PM
	This message has been viewed 15 times.
In Reply To	Alrite, Bring on the Ideas!! posted by CaptanZap(OK 2 B NA) on December 03, 2001 at 07:36 PM
Message	since you're gonna pay for front engine work again, might as well do the UD pulley. Is the 650 for JUST labor? If so that's freakin STEEP, seriously. At least make the pulley and thermostat included in that cost (thermostat shoulda been done at 60k too). :\
Follow Ups	Alrite, Bring on the Ideas!! - CaptanZap(OK 2 B NA) 19:36:23 12/03/01 should have changed it during 60k :) like to do it the hard> - Seb 19:40:31 12/03/01 hey were you at Bakersfield? w/ the cool stripes on the - CaptanZap(OK 2 B NA) 19:44:53 12/03/01 Yeah that was me....SEB! (n/m) - Seb 20:43:59 12/03/01 ok, now it helps cause i thought you said "SUB" i was like.. - CaptanZap(OK 2 B NA) 22:51:32 12/03/01 race cams, higher comp. pistons, Ti rods, full blueprinting> - snoguitar(NA Zz R SLO) 19:41:04 12/03/01 good ideas, JWT cams recommended? (n/m) - CaptanZap(OK 2 B NA) 19:45:38 12/03/01 only if you want to pay yet another $500ish for labor>>> - snoguitar(NA Zz R SLO) 19:52:20 12/03/01 Should had this discussion before the 60k, but... - DanZMan (SF bay) 20:01:48 12/03/01
Post a Followup	You cannot reply to this message because you are not logged in.