Subject	in lieu of the post below, ud pulley question, good or bad
Posted by	Chris (NJ) on November 29, 2001 at 9:25 PM
	This message has been viewed 19 times.
Message	hehe, not really, i know that will never be answered. but, what i do wonder, for the engines that have been *ruined* by the ud pulley, has anyone tried to decide if it was one manufacturer over another? i had a unorthodox on my na for a long time, and since i know the new owner, the engine is still fine, probably 25k miles later. are the engines that are spinning rods, using the auto spec. pulley? and not unorthodox or vice versa? just curious. laterz chris "If I would have known addiction was this expensive I would have seen a shrink a long time ago."(BadZCar(FL)) aim=ylwttz 1990 custom yellow stage X TT 1990 2+2 stage 4+ (sold)
Follow Ups	in lieu of the post below, ud pulley question, good or bad - Chris (NJ) 21:25:55 11/29/01 detonation cause more damage to engine bearings. - nixit(da][as) 21:30:57 11/29/01 well, putting aside everyones opinion on these. - Chris (NJ) 21:36:39 11/29/01 what problem? - nixit(da][as) 21:51:57 11/29/01 dont be a dick, i have searched plenty, and been around - Chris (NJ) 21:59:35 11/29/01 define "non bias" - Elguapo (Dallas) 22:09:25 11/29/01 Re: define "non bias" - Chris (NJ) 22:15:11 11/29/01 very biased specific answer as I see the world thru my eyes. - nixit(da][as) 22:15:22 11/29/01 thank you - Chris (NJ) 22:22:39 11/29/01 so, please grade my post. A-F. I deserve that. No arguments? (n/m) - nixit(da][as) 22:25:58 11/29/01 ok, - Chris (NJ) 22:36:46 11/29/01 troublemakerb ... :-) (n/m) - Elguapo (Dallas) 22:26:00 11/29/01 and.... - FLY 1 (Dallaz) 23:28:13 11/29/01
Post a Followup	You cannot reply to this message because you are not logged in.