TwinTurbo.NET: Nissan 300ZX forum - Glad I built my own flowbench then.... >>>
People Seeking Info
 
   


     
Subject Glad I built my own flowbench then.... >>>
     
Posted by AshsZ (Retired) on November 15, 2001 at 3:37 PM
  This message has been viewed 22 times.
     
In Reply To RC Engineering warning posted by wickdGSXR on November 15, 2001 at 02:34 PM
     
Message I was thinking of sending my 550's to them for cleaning and flow balancing. The person I spoke with was quite informative.. I just wasn't about to dump $30 a pop for them to clean and flowbalance them. Instead, I built a flowbench of my own for $30. Ha! It works like a charm.


: I have put about 2000 miles on my RC Engineering 550 injectors. So far I've pulled the motor TWICE, same cylinder going to crap. RC just checked my injectors and says one is history, not rebuildable...pure junk. How the f* can this happen? How long will I be able to go before my injectors burn another cylinder? They suck ass.

My CarPuter Headquarters:

[ ashleypowers.com ]
agpowers@bellsouth.net

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.