Subject	I read somewhere that the RC TB is 3mm over ->
Posted by	MikeeZ on October 31, 2001 at 2:35 PM
	This message has been viewed 21 times.
In Reply To	Are you sure the TB can be bored out 3mm over? (n/m) posted by MikeH(Phoenix) on October 31, 2001 at 02:18 PM
Message	That's about an 1/8th of an inch diameter - And I really think its unnecessary until about 800bhp.. Check w/ RC or SGP to make sure.. I remember hearing some time back someone used a pair of 240sx or z31 TB's, took some trickery.. MikeeZ Twin Turbo, Almost BPU Funny TT.net quotes: OK, well I've heard that 9 inches is a good size - F8IZHIS 10/09/01 02:47:48
Follow Ups	Reply to talk about extrude honing plenum -> - MikeeZ 13:45:10 10/31/01 Are you sure the TB can be bored out 3mm over? (n/m) - MikeH(Phoenix) 14:18:45 10/31/01 I read somewhere that the RC TB is 3mm over -> - MikeeZ 14:35:58 10/31/01 Hell Project Z's car has RC throttle bodies 4mm bigger than - ZBlacktt 15:02:27 10/31/01 Who can make them that much bigger? (n/m) - MikeH(Phoenix) 23:49:26 10/31/01 Best bet, ask Mike :) (n/m) - ZBlacktt 00:48:01 11/01/01 I agree and I have the extrude honed upper and lower plunum> - NONE 16:30:01 10/31/01
Post a Followup	You cannot reply to this message because you are not logged in.