Subject	Disconnected the factory boost solenoid connectors?
Posted by	SpdDemon13 (Baltimore) on October 28, 2001 at 11:32 PM
	This message has been viewed 52 times.
In Reply To	Profec B driving me NUTS! Bout to throw in trash! HELP!!! posted by BCs300z (Back in the Saddle) on October 28, 2001 at 09:00 PM
Message	Sounds like a classic case of forgetting to disconnect the factory boost solenoid connectors. Why? You say when you take the box out of the picture, you run 10 psi steady. If you had the solenoids disconnected then you should only run 6-7 psi. Adding the box back in the picture under the current set up you have would cause you to pike the boost to what you have now (with boost jets in, you could hit over 20 pi). Hope this helps. Harry 1992 Z Twin Turbo - Stage 4+ 1993 Honda Prelude VTEC ICQ # 1553422 Check my site out! "OMG! I'm going straight to HELL!!!!" - Wolf [Pittsburgh] Click to find out why... LOL
Follow Ups	Profec B driving me NUTS! Bout to throw in trash! HELP!!! - BCs300z (Back in the Saddle) 21:00:30 10/28/01 Re: Profec B driving me NUTS! Bout to throw in trash! HELP!! - SirpriZ 22:49:54 10/28/01 that is exactly why I dont want to run that high. Thanks. (n/m) - BCs300z (Back in the Saddle) 22:54:08 10/28/01 Just go to the GReddy website, all instructions are on PDf.. - odspitfire 01:43:53 10/29/01 Re: Profec B driving me NUTS! Bout to throw in trash! HELP!! - SirpriZ 23:15:09 10/28/01 Disconnected the factory boost solenoid connectors? - SpdDemon13 (Baltimore) 23:32:42 10/28/01 Re: Disconnected the factory boost solenoid connectors? - SirpriZ 23:45:39 10/28/01 I don't even have the control soleniods on the engine. so... - BCs300z (Back in the Saddle) 00:04:13 10/29/01 Can you take a few pics? - SpdDemon13 (Baltimore) 12:16:53 10/29/01 Where are the boost solenoid connectors? I need to know - Kez43 11:22:48 10/29/01
Post a Followup	You cannot reply to this message because you are not logged in.