|
: the inner hole was not finish machined. When you held one of the other bushings along side you could see the difference. So there was some flashing on the edges or the inside was just rough? Odd since they are CNC machined by a computer that not going to forget to do something. I guess we'll have to do some spot checking on inner diameters. Thanks for the heads up on that... Yeah, you'll dig the rear end. When you go to mount it back to the frame, shoot a little undercoating on the upper & lower surfaces of the bushings & let them sit. Just a little insulation on there to kill high frequency noise w/o effecting the performance of the bushings. I did it to mine. ;-)
Later
|
