Subject	I would recommend a T04B/T3 with a stage 5 exhaust wheel and
Posted by	Z from Japan on October 10, 2001 at 8:40 PM
	This message has been viewed 37 times.
In Reply To	What do you guys think about T3/T4 turbos? posted by colbs19 on October 10, 2001 at 01:24 PM
Message	: Are they a good upgrade for $1000? Decent power gain? All input is appreciated. Thanks guys. a 60-1 hi-fi compressor. That should give you a decent spool up with max power in the 750rwhp range. If you build your bottom end and increase the displacement you could go with bigger turbos. I have Twin T04E/T3's 60-1 compressor with stage 5 exhaust that will be used on my Z. I have a lot of work done though. Email me and I will see if I can get you a pic of them. They are huge. 3.7L Z from Japan "Omae no kaachan debeso"
Follow Ups	What do you guys think about T3/T4 turbos? - colbs19 13:24:29 10/10/01 Carlos Ramirez has them, try emailing him (n/m) - Justin W. 13:27:17 10/10/01 he doesnt really have them. he has a T25/T28 variant i thin - Jefe 15:22:15 10/10/01 HKS 2530s have a TO4E(or B) compressor housing w/ T25 ex. - Chip 16:24:19 10/10/01 Re: HKS 2530s have a TO4E(or B) compressor housing w/ T25 ex - sparkie 19:08:16 10/10/01 what crack you been smoking? - Carlos Ramirez 07:09:42 10/11/01 Ok, I have a question - colbs19 10:20:20 10/11/01 lag is about 14PSI at 3900 RPMS - Carlos Ramirez 16:23:07 10/11/01 T3/T4 could be any T3 turbine/ Any T4 compressor combination - Chip 13:29:43 10/10/01 Dead on.. - MikeeZ 13:45:46 10/10/01 considerable lag.... (from someone who's driven TD06-20G) - Kiwi_Z 13:54:06 10/10/01 Not bad at all. - sparkie 14:06:51 10/10/01 I have 10cm~2. More for topend than spoolup. (n/m) - sparkie 14:10:36 10/10/01 would the 10cm work with tdo5-18g or is it too big? - Chip 16:22:58 10/10/01 I've seen 6,7,8cm~2 more commonly. 10 might work but... - sparkie 18:57:16 10/10/01 They are ok. - sparkie 13:40:34 10/10/01 I would recommend a T04B/T3 with a stage 5 exhaust wheel and - Z from Japan 20:40:17 10/10/01
Post a Followup	You cannot reply to this message because you are not logged in.