Subject	Dead on..
Posted by	MikeeZ on October 10, 2001 at 1:45 PM
	This message has been viewed 22 times.
In Reply To	T3/T4 could be any T3 turbine/ Any T4 compressor combination posted by Chip on October 10, 2001 at 01:29 PM
Message	You have to remember that not only are there a variety of wheels, but these wheels come in a variety of different trims, which are in turn mated to a handful of different A/R housings. FYI, The T4 compressor wheels can get very large. In excess of 3" exducers, some with large trim. Expect considerable lag with these wheels if you're trying to spin them w/ 1.5L of motor. For reference, the big 20G wheel - found in the td06 kit - I believe is about a 2.68" exducer. MikeeZ Twin Turbo, Almost BPU Funny TT.net quotes: OK, well I've heard that 9 inches is a good size - F8IZHIS 10/09/01 02:47:48
Follow Ups	What do you guys think about T3/T4 turbos? - colbs19 13:24:29 10/10/01 Carlos Ramirez has them, try emailing him (n/m) - Justin W. 13:27:17 10/10/01 he doesnt really have them. he has a T25/T28 variant i thin - Jefe 15:22:15 10/10/01 HKS 2530s have a TO4E(or B) compressor housing w/ T25 ex. - Chip 16:24:19 10/10/01 Re: HKS 2530s have a TO4E(or B) compressor housing w/ T25 ex - sparkie 19:08:16 10/10/01 what crack you been smoking? - Carlos Ramirez 07:09:42 10/11/01 Ok, I have a question - colbs19 10:20:20 10/11/01 lag is about 14PSI at 3900 RPMS - Carlos Ramirez 16:23:07 10/11/01 T3/T4 could be any T3 turbine/ Any T4 compressor combination - Chip 13:29:43 10/10/01 Dead on.. - MikeeZ 13:45:46 10/10/01 considerable lag.... (from someone who's driven TD06-20G) - Kiwi_Z 13:54:06 10/10/01 Not bad at all. - sparkie 14:06:51 10/10/01 I have 10cm~2. More for topend than spoolup. (n/m) - sparkie 14:10:36 10/10/01 would the 10cm work with tdo5-18g or is it too big? - Chip 16:22:58 10/10/01 I've seen 6,7,8cm~2 more commonly. 10 might work but... - sparkie 18:57:16 10/10/01 They are ok. - sparkie 13:40:34 10/10/01 I would recommend a T04B/T3 with a stage 5 exhaust wheel and - Z from Japan 20:40:17 10/10/01
Post a Followup	You cannot reply to this message because you are not logged in.