Subject	thanks..can someone else verify? (n/m)
Posted by	Seb300ZX on September 25, 2001 at 5:55 PM
	This message has been viewed 12 times.
In Reply To	I measured mine after compression, they were .050 (n/m) posted by twinz300 (RN Racing) on September 25, 2001 at 05:54 PM
Message
Follow Ups	copper head gasket group buy if interseted - twinz300 (RN Racing) 17:51:58 09/25/01 What's the thickness of stock gaskets? (n/m) - Seb300ZX 17:52:56 09/25/01 I measured mine after compression, they were .050 (n/m) - twinz300 (RN Racing) 17:54:56 09/25/01 thanks..can someone else verify? (n/m) - Seb300ZX 17:55:38 09/25/01 What would be a good thickness? Will these fit perfectly? - GqRaCeRx 18:06:32 09/25/01 Why so cheap? greddys are link 500 bucks - TARGETZ 18:07:15 09/25/01 because its just a gasket it shouldn't be $500 bucks (n/m) - Carlos Ramirez 18:46:14 09/25/01 agreed... - TARGETZ 18:57:17 09/25/01 I would think so ... (n/m) - Carlos Ramirez 19:03:28 09/25/01 these are good quality more read on - twinz300 (RN Racing) 18:17:09 09/25/01 Whats up Mike so you think I should get these?>>>>> - NONE 18:26:13 09/25/01 NONE (Jim) might as well pick up a set find out how thick - twinz300 (RN Racing) 04:44:22 09/26/01 k...just saw this one ... >>>>> - wesman [92TT-less ] 19:47:34 09/25/01 You have to use an o-ring for the Greddy's, also? (n/m) - GqRaCeRx 20:10:44 09/25/01 No need to O-ring block with Greddy gaskets (n/m) - 96-2+2TT(NYC) 20:44:57 09/25/01 yes, Greddy is 400-500.00 and the nismo ones are 400.00 (n/m) - twinz300 (RN Racing) 18:19:03 09/25/01 I think I'm in.. What's so good about copper? Pls advise. (n/m) - AshsZ (Retired) 18:33:49 09/25/01 lol your in but you dont know anything about them :-) (n/m) - TARGETZ 18:44:07 09/25/01 I know they're better than stock, I just wanna be sold on it (n/m) - AshsZ (Retired) 19:21:44 09/25/01 Ash, if your head and block are true they cannot blow out. - Z from Japan 19:30:07 09/25/01 What sort of mods needed to run them ? >>>> - wesman [92TT-less ] 19:37:34 09/25/01 read his message link inside... - TARGETZ 19:56:52 09/25/01 Yeah I saw that after I posted on this one :) (n/m) - wesman [92TT-less ] 20:52:18 09/25/01
Post a Followup	You cannot reply to this message because you are not logged in.