Subject	Pull the wire wrapping off to get to the wire>>>
Posted by	RT on September 19, 2001 at 2:30 PM
	This message has been viewed 9 times.
In Reply To	can anyone please advise on this? (n/m) posted by maverick (NYC) on September 19, 2001 at 01:51 PM
Message	and pull the connector out of the housing. Most can be pushed out with small screw driver. Cut wire add a few inches and reconnect to the connector. Solder and insulate and it is done.
Follow Ups	should i risk doing this?? >> - maverick (NYC) 12:35:38 09/19/01 Can't you just extend the wire you need? (n/m) - FLYT 300 12:47:42 09/19/01 can't. there's not enough slack cuz its frayed at the >> - maverick (NYC) 13:41:51 09/19/01 I'd carefully cut into the harness and only work on 1 wire - FLYT 300 14:09:05 09/19/01 can anyone please advise on this? (n/m) - maverick (NYC) 13:51:29 09/19/01 Pull the wire wrapping off to get to the wire>>> - RT 14:30:57 09/19/01
Post a Followup	You cannot reply to this message because you are not logged in.