Subject	I'd carefully cut into the harness and only work on 1 wire
Posted by	FLYT 300 on September 19, 2001 at 2:09 PM
	This message has been viewed 10 times.
In Reply To	can't. there's not enough slack cuz its frayed at the >> posted by maverick (NYC) on September 19, 2001 at 01:41 PM
Message	Peel back just enough of the casing so that you can get to enough of the wire you need to extend. Then solder on a new, longer wire and seal it all back up. I wouldn't try to extend the entire harness. IE don't make more work for yourself. Especially if you can create problems in the process! Happy ZXing, Dan
Follow Ups	should i risk doing this?? >> - maverick (NYC) 12:35:38 09/19/01 Can't you just extend the wire you need? (n/m) - FLYT 300 12:47:42 09/19/01 can't. there's not enough slack cuz its frayed at the >> - maverick (NYC) 13:41:51 09/19/01 I'd carefully cut into the harness and only work on 1 wire - FLYT 300 14:09:05 09/19/01 can anyone please advise on this? (n/m) - maverick (NYC) 13:51:29 09/19/01 Pull the wire wrapping off to get to the wire>>> - RT 14:30:57 09/19/01
Post a Followup	You cannot reply to this message because you are not logged in.