Subject	should i risk doing this?? >>
Posted by	maverick (NYC) on September 19, 2001 at 12:35 PM
	This message has been viewed 15 times.
Message	one of the wires from the PTU/CAS is frayed near the top of the harness. this caused my z to misfire. so i soldered the connection and it was good. lately that connection seemed to loosen and there is a very slight misfire (you can hear it during the idle). because the wire was frayed off at the very top of the harness, there is absolutely no wire slack i can work with. so i was thinking...should i just cut off the entire harness, crack open the harness up to re-attach some more solid wire, and reconnect all of the wires together? do you see any danger in doing this? even if i cut off the harness entirely, all i have to do is re-splice a handful of wires together to get an electric current running right? i really don't want to do this, but i really can't work on the thing unless its off the car. please help with any advice. thanks. mike zxredline@yahoo.com 1990 PearlGold Stage3 NA
Follow Ups	should i risk doing this?? >> - maverick (NYC) 12:35:38 09/19/01 Can't you just extend the wire you need? (n/m) - FLYT 300 12:47:42 09/19/01 can't. there's not enough slack cuz its frayed at the >> - maverick (NYC) 13:41:51 09/19/01 I'd carefully cut into the harness and only work on 1 wire - FLYT 300 14:09:05 09/19/01 can anyone please advise on this? (n/m) - maverick (NYC) 13:51:29 09/19/01 Pull the wire wrapping off to get to the wire>>> - RT 14:30:57 09/19/01
Post a Followup	You cannot reply to this message because you are not logged in.