Subject	How are you going to creat turbulance on DYNO? The>>
Posted by	RT on September 19, 2001 at 11:46 AM
	This message has been viewed 12 times.
In Reply To	Solution to end the arguments >>> posted by Z U N L on September 19, 2001 at 11:13 AM
Message	problem with holes are at speed, not sitting still 0n a dyno. To really solve cutt holes and add duct work to take air over top of engine, may cool it a bit and not cause turbulence in air filter area.
Follow Ups	cutting holes into the stillen louvered panel >> - maverick (NYC) 09:57:34 09/19/01 i can answer #2 for ya - Chris (NJ) 10:01:56 09/19/01 My louvered panel is cut opened too... - Lady300Z 10:07:15 09/19/01 I've heard you will lose HP because its a high pressure zone (n/m) - Majed 10:03:20 09/19/01 Where did you Hear that? (n/m) - VeeZee 10:04:03 09/19/01 I heard it from someone on this forum before>> - Majed 10:12:43 09/19/01 I wouldn't think you would lose hp.. prob not gain much eith - Z U N L 10:08:38 09/19/01 1 & 2 - wcoffey 10:07:09 09/19/01 Creates turbulent air... - crZ32 10:29:34 09/19/01 Re: Creates turbulent air... - VeeZee 10:34:11 09/19/01 Some corrections and arguements to your response. - SpdDemon13 (Baltimore) 11:25:10 09/19/01 I wouldn't recommend it, some answers inside >>>- - SpdDemon13 (Baltimore) 10:56:46 09/19/01 Solution to end the arguments >>> - Z U N L 11:13:43 09/19/01 How are you going to creat turbulance on DYNO? The>> - RT 11:46:26 09/19/01 BIIIIIIIIG fan! high power air compressor? - Z U N L 14:52:27 09/19/01
Post a Followup	You cannot reply to this message because you are not logged in.