Subject	here's the best article i found
Posted by	nixit(da][as) on September 11, 2000 at 11:14 AM
	This message has been viewed 39 times.
In Reply To	Re: AVC-R question and tip posted by RichZ on September 11, 2000 at 11:07 AM
Message	Boost Controller install ([ http://www.frontiernet.net/~tomb/BoostController.html ]) it's a little (read: alot) vague. TTnet will have a highly detailed, TECH article (install only i think) on the SuperAVC-R boost controller soon (about a month). : I am looking at tackling this. I have the AVC-R ready to install, but sitll need a good install directions. I am unsure of where to tap into the boost lines.... : : My AVC-R readout unit gets real warm. Is this normal? Also, I wired in a relay to the apexi boost control solenoid and powered it with one of the stock wastegate power plugs. Safety boost now active. Thanks Steve ....nixit....
Follow Ups	AVC-R question and tip - SWL 11:03:34 09/11/00 Re: AVC-R question and tip - RichZ 11:07:02 09/11/00 here's the best article i found - nixit(da][as) 11:14:28 09/11/00 http://pages.prodigy.net/carlosrg/avcr-faq/avcr-install.htm (n/m) - Carlos Ramirez 11:43:47 09/11/00 WOW!, Even better... - nixit(da][as) 11:56:25 09/11/00 hey you re right is suppose to be headlites :- - Carlos Ramirez 12:25:55 09/11/00 just give the pin numbers. make em goto the service manual> - nixit(da][as) 12:34:21 09/11/00
Post a Followup	You cannot reply to this message because you are not logged in.