Although I already have them and everything checks out and works fine. I used 10 ohm 10W resistors which bump the resistance from 3ohms to 13 ohms and the 10W resistance will lower the current that the injectors see as to save the coils from overload. Problem is that these damn resistors are like 3/8" X 3/8" X 2.5". Pretty long suckers, but they will all fit nicely under the plastic plenum cover. I have tested the triggering of the injectors on my flow bench I built. :) They are all within 0.5cc/min of each other and the spray patterns look hella nice and consistent.
: to run these. Not everyone is going to want to splice into their injector harnesses to get the correct OHM output from their injectors....it's playing with fire IMO...literally...something shorts or messes up it's bye bye Z..
My CarPuter Headquarters: [ ashleypowers.com ] agpowers@bellsouth.net
