TwinTurbo.NET: Nissan 300ZX forum - That was my plan orignally butI choked on forged prices>>>
People Seeking Info
 
   


     
Subject That was my plan orignally butI choked on forged prices>>>
     
Posted by AshsZ (Jobless In Florida) on August 22, 2001 at 8:57 AM
  This message has been viewed 18 times.
     
In Reply To Looks good, dude. It look as if you've done lots of homework posted by Pops on August 22, 2001 at 08:00 AM
     
Message I was getting quotes of $1000 for pistons, and another $800 for the rods. Cough hack gasp! Perhaps when I sell the NA engine and tranny I *could* buy rods and pistons, but I also figure that since the bottom end is strong up to around 600RWHP, that's plenty nuf for me. I want to just break into the 11s, have the track tell me to put a roll cage on it, and then I'm done. :) It'll probably take a 60-100 shot of nos, but I'll get there.


: But, since you've done all the labor yourself, it would have been nice to go for broke and go for big power...
: Good luck...

My CarPuter Headquarters:

[ ashleypowers.com ]
agpowers@bellsouth.net

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.