Subject	Nope camber kit was loose and was rotating freely (n/m)
Posted by	PLEAZURE in CA (SD) on August 21, 2001 at 3:18 PM
	This message has been viewed 49 times.
In Reply To	Hmmm, could the bad motor mounts have been the >>> posted by Barry'Z(FtLee,NJ) on August 21, 2001 at 12:57 PM
Message
Follow Ups	Greg removed my cross member and both engine mounts fell off - PLEAZURE in CA (SD) 12:42:05 08/21/01 You should replace those motor mounts while you have the>> - JRH(KY) 12:51:05 08/21/01 Hmmm, could the bad motor mounts have been the >>> - Barry'Z(FtLee,NJ) 12:57:07 08/21/01 Nope camber kit was loose and was rotating freely (n/m) - PLEAZURE in CA (SD) 15:18:29 08/21/01 Bummer, thanks for the info. (n/m) - Barry'Z(FtLee,NJ) 20:33:29 08/21/01 FYI, my 300degree camber kit does not touch anything. - Chip 14:13:02 08/21/01 every car is different, some engines even sit a little highe - PLEAZURE in CA (SD) 15:20:10 08/21/01 No 1 makes polyurethane motor mounts, sucks (n/m) - MikeH(Phoenix) 15:24:43 08/21/01
Post a Followup	You cannot reply to this message because you are not logged in.