Subject	Perfect Jeremy. Thanks, just the info I needed. Yes I had
Posted by	ctheobal on June 04, 2025 at 5:24 PM
	This message has been viewed 44 times.
In Reply To	If you removed the mounts, you'll need to leave them loose posted by Ghoztt (MD) on June 04, 2025 at 04:29 PM
Message	to replace the oil pan gasket. I will leave the trans mounts loose until all the trans bolts are started/snugged.
Follow Ups	Shield behind the flywheel. Is it needed? - ctheobal 17:04:36 06/03/25 Re: Shield behind the flywheel. Is it needed? - Kvert 18:04:35 06/03/25 Re: Re: Shield behind the flywheel. Is it needed? - ctheobal 18:36:04 06/03/25 Make sure they are facing the right direction (n/m) - Ghoztt (MD) 18:44:24 06/03/25 Re: Make sure they are facing the right direction - ctheobal 18:55:23 06/03/25 Use the two dowel pins at 3 and 9 for alignment (n/m) - itsa300zx 19:27:42 06/03/25 Yes I have the alignment dowels in. (n/m) - ctheobal 20:34:33 06/03/25 And you're not tightening 1 side before all of the bolts - Ghoztt (MD) 09:58:48 06/04/25 I have not attached the trans yet. I was trying to get - ctheobal 14:55:57 06/04/25 If you removed the mounts, you'll need to leave them loose - Ghoztt (MD) 16:29:13 06/04/25 Perfect Jeremy. Thanks, just the info I needed. Yes I had - ctheobal 17:24:57 06/04/25 Never had any issues with it. - Bernie (NoVA) 20:20:19 06/03/25 My other Z was fine. Not sure why this one is a problem. - ctheobal 20:33:22 06/03/25 Loosen the lower bell braces? (n/m) - Bernie (NoVA) 13:32:21 06/08/25 Yeah Bernie, that is what I am going to do. Thanks (n/m) - ctheobal 19:07:07 06/09/25 Keep the guillotine... it's annoying but necessary (n/m) - vorpalZed 00:18:23 06/04/25 Thanks Rob. I am going to try some things but - ctheobal 10:06:14 06/04/25
Post a Followup	You cannot reply to this message because you are not logged in.