Subject	My other Z was fine. Not sure why this one is a problem.
Posted by	ctheobal on June 03, 2025 at 8:33 PM
	This message has been viewed 50 times.
In Reply To	Never had any issues with it. posted by Bernie (NoVA) on June 03, 2025 at 08:20 PM
Message	Seems to be where the small shield goes up against the oil pan pushing the alignment of the holes off just enough for the bolts to not align properly.
Follow Ups	Shield behind the flywheel. Is it needed? - ctheobal 17:04:36 06/03/25 Re: Shield behind the flywheel. Is it needed? - Kvert 18:04:35 06/03/25 Re: Re: Shield behind the flywheel. Is it needed? - ctheobal 18:36:04 06/03/25 Make sure they are facing the right direction (n/m) - Ghoztt (MD) 18:44:24 06/03/25 Re: Make sure they are facing the right direction - ctheobal 18:55:23 06/03/25 Use the two dowel pins at 3 and 9 for alignment (n/m) - itsa300zx 19:27:42 06/03/25 Yes I have the alignment dowels in. (n/m) - ctheobal 20:34:33 06/03/25 And you're not tightening 1 side before all of the bolts - Ghoztt (MD) 09:58:48 06/04/25 I have not attached the trans yet. I was trying to get - ctheobal 14:55:57 06/04/25 If you removed the mounts, you'll need to leave them loose - Ghoztt (MD) 16:29:13 06/04/25 Perfect Jeremy. Thanks, just the info I needed. Yes I had - ctheobal 17:24:57 06/04/25 Never had any issues with it. - Bernie (NoVA) 20:20:19 06/03/25 My other Z was fine. Not sure why this one is a problem. - ctheobal 20:33:22 06/03/25 Loosen the lower bell braces? (n/m) - Bernie (NoVA) 13:32:21 06/08/25 Yeah Bernie, that is what I am going to do. Thanks (n/m) - ctheobal 19:07:07 06/09/25 Keep the guillotine... it's annoying but necessary (n/m) - vorpalZed 00:18:23 06/04/25 Thanks Rob. I am going to try some things but - ctheobal 10:06:14 06/04/25
Post a Followup	You cannot reply to this message because you are not logged in.