Subject	Use the two dowel pins at 3 and 9 for alignment (n/m)
Posted by	itsa300zx on June 03, 2025 at 7:27 PM
	This message has been viewed 44 times.
In Reply To	Re: Make sure they are facing the right direction posted by ctheobal on June 03, 2025 at 06:55 PM
Message
Follow Ups	Shield behind the flywheel. Is it needed? - ctheobal 17:04:36 06/03/25 Re: Shield behind the flywheel. Is it needed? - Kvert 18:04:35 06/03/25 Re: Re: Shield behind the flywheel. Is it needed? - ctheobal 18:36:04 06/03/25 Make sure they are facing the right direction (n/m) - Ghoztt (MD) 18:44:24 06/03/25 Re: Make sure they are facing the right direction - ctheobal 18:55:23 06/03/25 Use the two dowel pins at 3 and 9 for alignment (n/m) - itsa300zx 19:27:42 06/03/25 Yes I have the alignment dowels in. (n/m) - ctheobal 20:34:33 06/03/25 And you're not tightening 1 side before all of the bolts - Ghoztt (MD) 09:58:48 06/04/25 I have not attached the trans yet. I was trying to get - ctheobal 14:55:57 06/04/25 If you removed the mounts, you'll need to leave them loose - Ghoztt (MD) 16:29:13 06/04/25 Perfect Jeremy. Thanks, just the info I needed. Yes I had - ctheobal 17:24:57 06/04/25 Never had any issues with it. - Bernie (NoVA) 20:20:19 06/03/25 My other Z was fine. Not sure why this one is a problem. - ctheobal 20:33:22 06/03/25 Loosen the lower bell braces? (n/m) - Bernie (NoVA) 13:32:21 06/08/25 Yeah Bernie, that is what I am going to do. Thanks (n/m) - ctheobal 19:07:07 06/09/25 Keep the guillotine... it's annoying but necessary (n/m) - vorpalZed 00:18:23 06/04/25 Thanks Rob. I am going to try some things but - ctheobal 10:06:14 06/04/25
Post a Followup	You cannot reply to this message because you are not logged in.