TwinTurbo.NET: Nissan 300ZX forum - TwinZ front lip (US Spec bumper)
People Seeking Info
 
   


     
Subject TwinZ front lip (US Spec bumper)
     
Posted by VinZmax on October 18, 2022 at 11:15 AM
  This message has been viewed 179 times.
     
     
Message Has anyone installed a TwinZ front US spec lip? I'm getting to finally installing mine and I did it with just the stock bolts for now to see how it would look.
It looks good but not driveable yet. It needs the extras support of where TwinZ designed the places to drill the lip and supposedly to drill the stock bumper.
The edges of the lip need to come up a bit to reach the lower bumper, so I'm wondering what would be good to use and what would be strong enough to hold. I don't want to remove the bumper to install it. If I did, then I'd need to use bolts/washers/nuts. But without pulling it the front bumper off, I'm thinking some kind of insert into the lower bumper may work.

Wondering if anyone has tried rubber nutzerts or anything like that and if they held up.
Thanks,
Vinnie

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.