Message |
I unplugged the connector on the left side of the cluster, the one of two that clip on the outside edge of the cluster panel. Brake bulb warning light went out, so I know this is the feed to the panel of four (4) warning bulbs: Washer ABS HICAS Stop/Tail After looking at a couple wiring diagrams, I am pretty certain the two wires, a red / yellow, and a purple, shown in the upper right hand corner in this pic are the feeds to the Stop Tail warning light. Rather than cut the wires, I will try to de-pin these two. This will take some time because my de-pinning skills are severly lacking. But I wanted to post my progress so far, and maybe help someone else who wants to neutralize the Brake Bulb Warning Light. x

_________________________________________________
|
 |