Subject	Re: Sensor placement questions for going to standalone
Posted by	RBS145 on December 30, 2021 at 6:39 AM
	This message has been viewed 251 times.
In Reply To	Sensor placement questions for going to standalone posted by Woodnutz (PA) on December 29, 2021 at 12:26 PM
Message	I did this over the summer as well. I used two JWT Dummy MAF's for the filter setup. My IAT is tapped into the rear passenger corner of the upper plenum, seems to work well there. No issues so far.
Follow Ups	Sensor placement questions for going to standalone - Woodnutz (PA) 12:26:12 12/29/21 If you don't mind sharing, what are you looking at for full - J-Mart 13:37:23 12/29/21 If you're asking what sensors I'll be using (physical - Woodnutz (PA) 05:40:37 12/30/21 Re: Sensor placement questions for going to standalone - ouikikazz 17:54:14 12/29/21 That's pretty slick (n/m) - Ted (92TT) 22:30:06 12/29/21 That is a pretty clean solution. I'll have to keep that - Woodnutz (PA) 05:41:49 12/30/21 I'd recommend running a catch can with that solution if you - MixManMash 10:13:56 12/30/21 Agreed. Looks clean but there is oil contamination - ConVerTT 09:46:49 01/02/22 Re: Sensor placement questions for going to standalone - RBS145 06:39:33 12/30/21 Thanks for the feedback, guys! Very helpful - Woodnutz (PA) 07:52:09 01/11/22
Post a Followup	You cannot reply to this message because you are not logged in.