Subject	If you're asking what sensors I'll be using (physical
Posted by	Woodnutz (PA) on December 30, 2021 at 5:40 AM
	This message has been viewed 271 times.
In Reply To	If you don't mind sharing, what are you looking at for full posted by J-Mart on December 29, 2021 at 01:37 PM
Message	arrangement is TBD), here's what I've got lined up thus far: - IAT from Haltech unit (300ZX PnP kit). - Using onboard MAP sensor of the Elite 2000. - Continental flex fuel sensor in return line. - Haltech WB2 controller w/ Bosch O2 sensors. - All other OEM sensors that will be fed in to the ECU, as expected, although I guess the narrow-band O2 sensors won't be used anymore. I think that's everything, but I'm learning as I go with this. - Aaron
Follow Ups	Sensor placement questions for going to standalone - Woodnutz (PA) 12:26:12 12/29/21 If you don't mind sharing, what are you looking at for full - J-Mart 13:37:23 12/29/21 If you're asking what sensors I'll be using (physical - Woodnutz (PA) 05:40:37 12/30/21 Re: Sensor placement questions for going to standalone - ouikikazz 17:54:14 12/29/21 That's pretty slick (n/m) - Ted (92TT) 22:30:06 12/29/21 That is a pretty clean solution. I'll have to keep that - Woodnutz (PA) 05:41:49 12/30/21 I'd recommend running a catch can with that solution if you - MixManMash 10:13:56 12/30/21 Agreed. Looks clean but there is oil contamination - ConVerTT 09:46:49 01/02/22 Re: Sensor placement questions for going to standalone - RBS145 06:39:33 12/30/21 Thanks for the feedback, guys! Very helpful - Woodnutz (PA) 07:52:09 01/11/22
Post a Followup	You cannot reply to this message because you are not logged in.