TwinTurbo.NET: Nissan 300ZX forum - I did a bit of testing...
People Seeking Info
 
   


     
Subject I did a bit of testing...
     
Posted by LitlElvis on November 26, 2021 at 12:44 PM
  This message has been viewed 314 times.
     
In Reply To Re: Re: Just PNs and RH LH marks moulded into the back of them posted by Kvert on November 23, 2021 at 10:09 AM
     
Message 1) sinks in water

2) Acetone does not affect the material

3) burn test 1 - self extinguishes when flame is removed

4) burn test 2 - does not drip when exposed to flame

Based upon these observations and using this plastic identification flow chart:

(https://www.stanmech.com/uploads/2/1/0/9/21099874/plastics_identification_flow_chart.pdf)

I think these parts are made from a PPE or Polyphenylene Ether.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.