Subject	Just don’t port it too much…lol
Posted by	Stanky (BC) on July 14, 2021 at 6:58 PM
	This message has been viewed 210 times.
In Reply To	Recommendations on shops for head porting? posted by Madhatter10-6 on July 14, 2021 at 11:59 AM
Message	A member here(others can attest to this here) had a massive boost leak from the lower plenum gaskets because his heads were ported too much, causing the gasket to not seal properly… on dyno day… but we managed to “fix” it that day via an unconventional method lol I’m sure porting will help you out as air flow is everything, but I cant give you any real world numbers
Follow Ups	Recommendations on shops for head porting? - Madhatter10-6 11:59:04 07/14/21 My most recent go around, I had cores sent to SZ to have - MixManMash 13:21:08 07/14/21 Forgot to mention - I haven't put my engine back together - MixManMash 13:22:24 07/14/21 . - Mike@ZSpeed 16:00:16 07/14/21 How long ago did you send them to SZ?...>>> - 5150Z 09:02:09 07/15/21 It was at least 2 years ago. (n/m) - MixManMash 17:46:43 07/15/21 Oh-oh... " While I'm in There" Syndrome! (n/m) - ZXoltan 14:47:12 07/14/21 Overkill unless you are racing the Z. - CmyZ 17:49:44 07/14/21 This (n/m) - ForceFedTT 21:09:09 07/14/21 Yep. I was planning on mild porting recently...>>> - 5150Z 09:20:41 07/15/21 Just don’t port it too much…lol - Stanky (BC) 18:58:06 07/14/21 Lol. Good times. Bet that mistake is never made by him - MixManMash 00:00:56 07/15/21 Re: Recommendations on shops for head porting? - NIVO88T 17:11:26 07/15/21 +1 for NIVO88T - induetime 16:09:17 07/21/21 Dave @ https://headgamesmotorworks.com/ (n/m) - josh 17:16:55 07/15/21
Post a Followup	You cannot reply to this message because you are not logged in.