TwinTurbo.NET: Nissan 300ZX forum - the jack handle is clipped down when not in use
People Seeking Info
 
   


     
Subject the jack handle is clipped down when not in use
     
Posted by vorpalZed on June 03, 2021 at 3:37 PM
  This message has been viewed 147 times.
     
In Reply To Great minds think alike posted by robo (sebring1970) on June 03, 2021 at 03:06 PM
     
Message so it only would contact the wheel when you're jacking the wheel rollers together to lift the tire. My AVS VS5's have a curved spoke that means I couldn't lift the handle to jack the tire up because the dolly had to roll too far under the car to contact the full tire tread width and the handle rise would hit the wheel above the tire.

Also, the dollies do stick out from the side of the tire about 8-10"... just enough to catch your ankle and trip you if you're not careful... also means you have a bit of space between the side of the car and a wall... which is good, keeps door dings down.

Sure roll nice, tho

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.