Subject	OEM has rubber boot and no seal on the wire.
Posted by	Bernie (NoVA) on May 31, 2021 at 9:28 PM
	This message has been viewed 205 times.
In Reply To	Thanks Bernie. If I recall correctly the OEM version posted by ZXoltan on May 30, 2021 at 09:38 PM
Message	Just like 1st gen injector connectors, MAF, PTU etc. All those rubber boots break down and let moisture in. For example: Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	Any useful feedback on Z1 wiring products? - ZXoltan 08:28:31 05/30/21 Have not used theirs - in house have been using WS for years (n/m) - Bernie (NoVA) 10:37:59 05/30/21 you should buy one of these. then compare to z1 or - slayer fan 13:11:23 05/30/21 Whatever that link is to, it does not work (n/m) - ZXoltan 14:46:39 05/30/21 better link - zantar 17:30:08 05/30/21 I wouldn't’ Buy one (n/m) - zantar 17:31:11 05/30/21 I hope that was a joke - ZXoltan 18:04:28 05/30/21 The WS harness knock harness is weather sealed on the wires, - Bernie (NoVA) 20:29:03 05/30/21 Thanks Bernie. If I recall correctly the OEM version - ZXoltan 21:38:36 05/30/21 OEM has rubber boot and no seal on the wire. - Bernie (NoVA) 21:28:18 05/31/21 i wouldn't buy it either, but i also don't completely - slayer fan 10:41:48 05/31/21 Let me know if you'd like a WS harness or knock sub. (n/m) - Bernie (NoVA) 17:13:37 06/02/21
Post a Followup	You cannot reply to this message because you are not logged in.