Subject	Any useful feedback on Z1 wiring products?
Posted by	ZXoltan on May 30, 2021 at 8:28 AM
	This message has been viewed 347 times.
Message	Specifically interested in any experience with the detonation sensor harness. They claim it is superior with regard to being moisture proof, which is important, but not if the connectors themselves fail. There are lots of choices out there including wiring specialties and Concept Z is also making their own. Its a relatively inexpensive part, but a PITA to replace, so looking for experiences with reliability. Also, anyone used the Z1 Engine (EGI) harness- any feedback?
Follow Ups	Any useful feedback on Z1 wiring products? - ZXoltan 08:28:31 05/30/21 Have not used theirs - in house have been using WS for years (n/m) - Bernie (NoVA) 10:37:59 05/30/21 you should buy one of these. then compare to z1 or - slayer fan 13:11:23 05/30/21 Whatever that link is to, it does not work (n/m) - ZXoltan 14:46:39 05/30/21 better link - zantar 17:30:08 05/30/21 I wouldn't’ Buy one (n/m) - zantar 17:31:11 05/30/21 I hope that was a joke - ZXoltan 18:04:28 05/30/21 The WS harness knock harness is weather sealed on the wires, - Bernie (NoVA) 20:29:03 05/30/21 Thanks Bernie. If I recall correctly the OEM version - ZXoltan 21:38:36 05/30/21 OEM has rubber boot and no seal on the wire. - Bernie (NoVA) 21:28:18 05/31/21 i wouldn't buy it either, but i also don't completely - slayer fan 10:41:48 05/31/21 Let me know if you'd like a WS harness or knock sub. (n/m) - Bernie (NoVA) 17:13:37 06/02/21
Post a Followup	You cannot reply to this message because you are not logged in.