Subject	I think your sarcasm detector is broken. (n/m)
Posted by	MixManMash on May 25, 2021 at 6:41 AM
	This message has been viewed 181 times.
In Reply To	Re: 384.....UD pulley and 400. Dial in the nos timing... posted by 93TTZ5401 on May 24, 2021 at 07:45 PM
Message
Follow Ups	How much power should I be making - 93TTZ5401 11:11:27 05/23/21 338.6 (n/m) - WhiTTe Z 11:22:40 05/23/21 1999, this is 2021 calling. Can you answer this question? (n/m) - Tanley (ATL) 14:34:11 05/23/21 Re: 1999, this is 2021 calling. Can you answer this question? - 93TTZ5401 14:48:35 05/23/21 The first guess isn’t too far off. You will need some better - bbug 20:41:13 05/23/21 not a clue... - vorpalZed 22:43:02 05/23/21 Wierd oil? Gotta watch out for that alien oil. - ForceFedTT 00:15:43 05/26/21 if you dyno let me know - JerseyTex 10:46:12 05/24/21 VorpalZed nailed it. Lots of variable beyond mods go into it - Zeus 12:18:28 05/24/21 now that was a good read indeed =) (n/m) - stockplayerz(nyc) 14:31:22 05/24/21 384.....UD pulley and 400. Dial in the nos timing... - ShakaShaun(Denver) 17:15:02 05/24/21 I'm just going to leave this here: - MixManMash 17:24:25 05/24/21 nice touch (n/m) - ShakaShaun(Denver) 17:50:08 05/24/21 Yea but can that all be done on Nistune? (n/m) - JerseyTex 19:14:07 05/24/21 I just use RTV on my fuel map holes (n/m) - Kvert 10:45:47 05/25/21 Word is you can use ultra gray for almost anything on a Z. (n/m) - Tanley (ATL) 11:11:08 05/25/21 ultra copper or GTFO (n/m) - vorpalZed 11:52:37 05/25/21 Truth brother! (n/m) - ConVerTT 23:09:45 05/25/21 I just use RTV on my fuel map holes (n/m) - Kvert 11:46:21 05/25/21 Duct tape, ftw! - ZXoltan 12:37:17 05/25/21 I use dialectic grease. (n/m) - Josher 17:44:12 05/25/21 Re: 384.....UD pulley and 400. Dial in the nos timing... - 93TTZ5401 19:45:09 05/24/21 I think your sarcasm detector is broken. (n/m) - MixManMash 06:41:09 05/25/21 Re: I think your sarcasm detector is broken. - 93TTZ5401 11:42:11 05/25/21 613.29.... wait... wrong thread? (n/m) - MeatMan (604Z) 13:03:15 05/25/21
Post a Followup	You cannot reply to this message because you are not logged in.