Subject	I’d contact Scat and see if they would recommend
Posted by	boileralum on April 28, 2021 at 7:55 PM
	This message has been viewed 129 times.
In Reply To	Can you helicoil a forged rod or will it fail ? posted by DanielThomas on April 26, 2021 at 04:25 PM
Message	drilling and tapping (by a machinist on a machine) a larger hole for a larger ARP bolt. Rule #1 - There's always a bastard!
Follow Ups	Can you helicoil a forged rod or will it fail ? - DanielThomas 16:25:48 04/26/21 I wouldnt do that on critical component. - ForceFedTT 17:40:19 04/26/21 Bad Idea - ZXoltan 18:29:11 04/26/21 You may want to contact EP Racing and see if they might - ZXoltan 18:30:46 04/26/21 Giggle... "He does a lot of SCAT's"... indeed (n/m) - LitlElvis 11:59:13 04/27/21 LMAO - I guess that term has the same meaning here LOL (n/m) - ConVerTT 20:12:53 04/27/21 LOL. I was totally unaware of that meaning - ZXoltan 10:06:18 04/28/21 I'd never risk that. (n/m) - Zeus 19:43:35 04/26/21 That’s a dicey one. If installed correctly... - Stanky (BC) 23:23:20 04/26/21 The engine from hell strikes again - LitlElvis 12:29:25 04/27/21 Re: The engine from hell strikes again - DanielThomas 16:27:27 04/27/21 You know the answer. Sorry. Yes it sucks. (n/m) - ConVerTT 20:10:09 04/27/21 There's single rods listed on some of the vendors's websites - ZaXxon 11:31:48 04/28/21 Re: There's single rods listed on some of the vendors's websites - DanielThomas 14:22:47 04/28/21 I’d contact Scat and see if they would recommend - boileralum 19:55:54 04/28/21 A larger bolt will throw that out of balance. (n/m) - itsa300zx 20:54:03 04/28/21 Not if you do it on all 12 holes (giggity) (n/m) - boileralum 22:21:57 04/28/21
Post a Followup	You cannot reply to this message because you are not logged in.