Subject	That likely had more to do with the coating not being
Posted by	BlackholeZ on April 15, 2021 at 5:03 PM
	This message has been viewed 167 times.
In Reply To	This was one example.... posted by Bernie (NoVA) on April 15, 2021 at 12:03 AM
Message	able to get in the cracks between the flanges and pipe. Corrosion is able to start on the bare metal and is encouraged by the tight space, and then works its way out under the coating. It's a very common failure mode, but speaks to the value of proper coating installation. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Average/ approximate cost for ceramic coating manifolds? - ZXoltan 19:23:56 04/10/21 I spent $325 to cerakote the long tube headers on my swap. - Gordo LSZ Daytona 20:12:44 04/10/21 Jet Hot quoted me ~400 sorta recently. (n/m) - Bernie (NoVA) 22:18:32 04/10/21 My quote was from last June. Maybe the price dropped? - ZXoltan 08:18:10 04/11/21 Well the last time I sent something to Jet Hot was 2005, I - Bernie (NoVA) 09:37:42 04/11/21 Yeah, I hear ya'. Their prices have more than doubled since - robo (sebring1970) 12:05:55 04/11/21 I should have mentioned, I always did their metallic - robo (sebring1970) 14:28:16 04/14/21 The sterling coating would burn through on DPs. it ran too - Bernie (NoVA) 15:04:00 04/14/21 The Jet Hot Sterling coating was rated for temperatures - robo (sebring1970) 16:40:54 04/14/21 Your 92 has 3 inch stainless when it crashed. - Bernie (NoVA) 23:38:35 04/14/21 This is good insight. Thanks for sharing. (n/m) - Zeus 13:21:19 04/15/21 Now he tells me <insert rolls eyes emoji> jaja (n/m) - robo (sebring1970) 08:17:26 04/18/21 This was one example.... - Bernie (NoVA) 00:03:23 04/15/21 That likely had more to do with the coating not being - BlackholeZ 17:03:42 04/15/21 Maybe - eventually surface rust popped on the tubes (n/m) - Bernie (NoVA) 18:58:24 04/15/21 Yeah I did see a few spots near the welds in the middle (n/m) - BlackholeZ 11:44:40 04/16/21 $300 for Swain... - ElectroZ 12:46:45 04/15/21 Per side or for the pair? I thought it was each side. (n/m) - ZXoltan 13:49:57 04/15/21 Re: Per side or for the pair? I thought it was each side. - ElectroZ 11:31:52 04/16/21 OK Interesting--thanks. - ZXoltan 15:40:41 04/16/21 Re: Average/ approximate cost for ceramic coating manifolds? - DanielThomas 16:15:18 04/15/21
Post a Followup	You cannot reply to this message because you are not logged in.