Subject	This was one example....
Posted by	Bernie (NoVA) on April 15, 2021 at 12:03 AM
	This message has been viewed 286 times.
In Reply To	The Jet Hot Sterling coating was rated for temperatures posted by robo (sebring1970) on April 14, 2021 at 04:40 PM
Message	JH sterling. Never mind the broken down pipe flange from the welds being ground out too thin. See the rust near the collector flange and spots forming on the pipes. When they aged it just got worse. Then I did mine in JT2000 Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	Average/ approximate cost for ceramic coating manifolds? - ZXoltan 19:23:56 04/10/21 I spent $325 to cerakote the long tube headers on my swap. - Gordo LSZ Daytona 20:12:44 04/10/21 Jet Hot quoted me ~400 sorta recently. (n/m) - Bernie (NoVA) 22:18:32 04/10/21 My quote was from last June. Maybe the price dropped? - ZXoltan 08:18:10 04/11/21 Well the last time I sent something to Jet Hot was 2005, I - Bernie (NoVA) 09:37:42 04/11/21 Yeah, I hear ya'. Their prices have more than doubled since - robo (sebring1970) 12:05:55 04/11/21 I should have mentioned, I always did their metallic - robo (sebring1970) 14:28:16 04/14/21 The sterling coating would burn through on DPs. it ran too - Bernie (NoVA) 15:04:00 04/14/21 The Jet Hot Sterling coating was rated for temperatures - robo (sebring1970) 16:40:54 04/14/21 Your 92 has 3 inch stainless when it crashed. - Bernie (NoVA) 23:38:35 04/14/21 This is good insight. Thanks for sharing. (n/m) - Zeus 13:21:19 04/15/21 Now he tells me <insert rolls eyes emoji> jaja (n/m) - robo (sebring1970) 08:17:26 04/18/21 This was one example.... - Bernie (NoVA) 00:03:23 04/15/21 That likely had more to do with the coating not being - BlackholeZ 17:03:42 04/15/21 Maybe - eventually surface rust popped on the tubes (n/m) - Bernie (NoVA) 18:58:24 04/15/21 Yeah I did see a few spots near the welds in the middle (n/m) - BlackholeZ 11:44:40 04/16/21 $300 for Swain... - ElectroZ 12:46:45 04/15/21 Per side or for the pair? I thought it was each side. (n/m) - ZXoltan 13:49:57 04/15/21 Re: Per side or for the pair? I thought it was each side. - ElectroZ 11:31:52 04/16/21 OK Interesting--thanks. - ZXoltan 15:40:41 04/16/21 Re: Average/ approximate cost for ceramic coating manifolds? - DanielThomas 16:15:18 04/15/21
Post a Followup	You cannot reply to this message because you are not logged in.