Subject	The sterling coating would burn through on DPs. it ran too
Posted by	Bernie (NoVA) on April 14, 2021 at 3:04 PM
	This message has been viewed 189 times.
In Reply To	I should have mentioned, I always did their metallic posted by robo (sebring1970) on April 14, 2021 at 02:28 PM
Message	hot for it. It's meant for carburetor headers. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	Average/ approximate cost for ceramic coating manifolds? - ZXoltan 19:23:56 04/10/21 I spent $325 to cerakote the long tube headers on my swap. - Gordo LSZ Daytona 20:12:44 04/10/21 Jet Hot quoted me ~400 sorta recently. (n/m) - Bernie (NoVA) 22:18:32 04/10/21 My quote was from last June. Maybe the price dropped? - ZXoltan 08:18:10 04/11/21 Well the last time I sent something to Jet Hot was 2005, I - Bernie (NoVA) 09:37:42 04/11/21 Yeah, I hear ya'. Their prices have more than doubled since - robo (sebring1970) 12:05:55 04/11/21 I should have mentioned, I always did their metallic - robo (sebring1970) 14:28:16 04/14/21 The sterling coating would burn through on DPs. it ran too - Bernie (NoVA) 15:04:00 04/14/21 The Jet Hot Sterling coating was rated for temperatures - robo (sebring1970) 16:40:54 04/14/21 Your 92 has 3 inch stainless when it crashed. - Bernie (NoVA) 23:38:35 04/14/21 This is good insight. Thanks for sharing. (n/m) - Zeus 13:21:19 04/15/21 Now he tells me <insert rolls eyes emoji> jaja (n/m) - robo (sebring1970) 08:17:26 04/18/21 This was one example.... - Bernie (NoVA) 00:03:23 04/15/21 That likely had more to do with the coating not being - BlackholeZ 17:03:42 04/15/21 Maybe - eventually surface rust popped on the tubes (n/m) - Bernie (NoVA) 18:58:24 04/15/21 Yeah I did see a few spots near the welds in the middle (n/m) - BlackholeZ 11:44:40 04/16/21 $300 for Swain... - ElectroZ 12:46:45 04/15/21 Per side or for the pair? I thought it was each side. (n/m) - ZXoltan 13:49:57 04/15/21 Re: Per side or for the pair? I thought it was each side. - ElectroZ 11:31:52 04/16/21 OK Interesting--thanks. - ZXoltan 15:40:41 04/16/21 Re: Average/ approximate cost for ceramic coating manifolds? - DanielThomas 16:15:18 04/15/21
Post a Followup	You cannot reply to this message because you are not logged in.