TwinTurbo.NET: Nissan 300ZX forum - I just did this with the headlamps and rad in place.
Subject
I just did this with the headlamps and rad in place.
Posted by
itsa300zx
on February 16, 2021 at 1:37 PM
This message has been viewed
191
times.
In Reply To
Question re: Specialty Z intake pipes
posted by Buckaroo Banzai
on February 16, 2021 at 12:21 PM
Message
No issues. Was harder to remove the oem pipes under the lights. Just remember to install the 2 turbo inlets before the engine goes in.LOL
Follow Ups
Question re: Specialty Z intake pipes
-
Buckaroo Banzai
12:21:06 02/16/21
I just did this with the headlamps and rad in place. -
itsa300zx
13:37:42 02/16/21
Re: I just did this with the headlamps and rad in place.
-
Buckaroo Banzai
15:00:48 02/16/21
Do you have the low profile engine mounts?
-
itsa300zx
15:38:33 02/16/21
Re: Do you have the low profile engine mounts?
-
Buckaroo Banzai
21:35:16 02/16/21
You'll be fine. That's how I did it. (n/m)
-
ZaXxon
13:38:52 02/16/21
Re: You'll be fine. That's how I did it.
-
Buckaroo Banzai
15:01:54 02/16/21
First drive after upgrades, no issues re-installing anything
-
ZaXxon
07:33:20 02/17/21
I don't suspect that'll be an issue
-
Zeus
14:02:01 02/16/21
Re: I don't suspect that'll be an issue
-
Buckaroo Banzai
15:03:50 02/16/21
You could try mocking it up first
-
Zeus
15:09:03 02/16/21
Swivel sockets or Swivel wrenches
-
ZXRider
11:47:30 02/17/21
Post a
Followup
You cannot reply to this message because you are not
logged in
.