TwinTurbo.NET: Nissan 300ZX forum - I can put that to my Z club guy
People Seeking Info
 
   


     
Subject I can put that to my Z club guy
     
Posted by vorpalZed on January 16, 2021 at 1:24 PM
  This message has been viewed 41 times.
     
In Reply To Re: fresh off the 3D printer posted by SRH on January 16, 2021 at 11:00 AM
     
Message who makes these bits on his printer... will need to find a set of stock ones so he can measure and model them and run off som e ABS copies and test them out.

I've got him working on those top radio bezel screw cover clips right now, will run that as the next project.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.