TwinTurbo.NET: Nissan 300ZX forum - Nicely done!
People Seeking Info
 
   


     
Subject Nicely done!
     
Posted by RobZ32 on January 12, 2021 at 5:38 PM
  This message has been viewed 66 times.
     
In Reply To fresh off the 3D printer posted by vorpalZed on January 12, 2021 at 04:26 PM
     
Message If you are printing them in ABS plastic you can put them in an acetone vapor bath to achieve a nice smooth finish. It will save you the sanding time and paint as well.

Rob


It's never "DONE", just finished enough to drive :-) - BigTDogg
(MA)


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.