Subject	Correct. You just need to add a solenoid for boost control
Posted by	MixManMash on September 28, 2020 at 12:36 PM
	This message has been viewed 135 times.
In Reply To	question for you posted by JerseyTex on September 28, 2020 at 12:16 PM
Message	and wire a Haltech output to drive it. Since you would add a MAP Sensor, you don't need dual MAF or a selin.
Follow Ups	Where's Jim? (or what to do with a failing Selin Device) - BoneZ (MD) 20:35:04 09/27/20 Yes go MAP!! Best thing I ever did.. - Stanky (BC) 22:46:51 09/27/20 I've been reading up on the Haltech - it looks promising. - BoneZ (MD) 23:31:11 09/27/20 Yep it’s up to date, Haltech is good but there are others - Stanky (BC) 23:36:40 09/27/20 After reading up, this is very appealing. I may put this on - Woodnutz (PA) 05:39:04 09/28/20 question for you - JerseyTex 12:16:16 09/28/20 Correct. You just need to add a solenoid for boost control - MixManMash 12:36:40 09/28/20 Yes and it can do more .. - Stanky (BC) 21:18:39 09/28/20 thank you both for your response - JerseyTex 03:54:05 09/29/20 Thanks to whoever got hold of Jim- he emailed. (n/m) - BoneZ (MD) 23:27:58 09/27/20 Guess I’m out of the loop: - Jkova300z 00:36:35 09/28/20 IDK, I just know he is busy now... - BoneZ (MD) 04:23:36 09/28/20 They are on back order. Expected in the fall. (n/m) - Bernie (NoVA) 00:24:57 09/29/20 Go MAP + Standalone - Madhatter10-6 08:21:08 09/28/20 For a basic Haltech setup, what would you budget? - Jkova300z 12:20:59 09/28/20 I recommend replacing the connectors with updated sealed - Bernie (NoVA) 09:00:07 09/28/20 Thanks Bernie. Jim recommends the same and is sending - BoneZ (MD) 11:49:45 09/28/20
Post a Followup	You cannot reply to this message because you are not logged in.