Subject	Option #1 with a 5 or 10mm spacer up front
Posted by	Colt on August 26, 2020 at 2:09 PM
	This message has been viewed 170 times.
In Reply To	Having 3-piece Weds Kranze LXZ wheels built. Offset help? posted by Vert93 (MN) on August 26, 2020 at 08:26 AM
Message	10.5 +17 is absolutely out unless you want to look like / \ 9.5 +32 rear is best if you want traction, will only require a fender lip roll with a 275 tire Fronts you want to be around a 18x9 +30 to avoid fender work. If willing to roll your fronts you could use a bit less offset upfront.
Follow Ups	Having 3-piece Weds Kranze LXZ wheels built. Offset help? - Vert93 (MN) 08:26:51 08/26/20 9.5s up front is tight, but +30 offset for the front would - nissubaru 09:05:22 08/26/20 I take back what I said about option #2, 10.5 and low offset - nissubaru 09:07:25 08/26/20 Thanks for your input! I am not that concerned with the tire - Vert93 (MN) 09:18:42 08/26/20 Tire size in the front is whatever, I was just bummed - nissubaru 10:05:09 08/26/20 I went through a similar exercise rebuilding my SSR wheels. - CameronSF 11:04:37 08/26/20 Re: I went through a similar exercise rebuilding my SSR wheels. - MightyAA 13:16:08 08/27/20 Re:rear fitament shot - MightyAA 13:27:54 08/27/20 Re: Re:rear fitament shot - twinturbozs 17:24:48 08/27/20 Beautiful setup / (n/m) - MightyAA 09:39:50 08/28/20 Pretty sure Lo-disk is going to be a problem ... - ConVerTT 11:48:26 08/26/20 Option #1 with a 5 or 10mm spacer up front - Colt 14:09:47 08/26/20 Thank you for the responses. Hopefully we can figure this - Vert93 (MN) 07:40:05 08/27/20
Post a Followup	You cannot reply to this message because you are not logged in.