TwinTurbo.NET: Nissan 300ZX forum - Powder coat guy wanted them off.
Subject
Powder coat guy wanted them off.
Posted by
jval
on August 22, 2020 at 1:37 PM
This message has been viewed
157
times.
In Reply To
Totally doable.
posted by ni[x]it
on August 22, 2020 at 01:27 PM
Message
He said the oven might damage the gaskets. I knocked out the only pin on the linkage but it still doesn't want to come apart.
Follow Ups
Throttle Body/Linkage Dissasembly
-
jval
21:39:01 08/21/20
Totally doable.
-
ni[x]it
13:27:23 08/22/20
Powder coat guy wanted them off. -
jval
13:37:46 08/22/20
Re: Throttle Body/Linkage Dissasembly
-
Kvert
13:29:45 08/22/20
Source for the bearings? (n/m)
-
ZXoltan
13:31:11 08/22/20
Re: Source for the bearings?
-
Kvert
14:00:23 08/22/20
I found a part number in an old post
-
jval
18:12:58 08/22/20
Re: I found a part number in an old post
-
Potacka
19:51:59 08/24/20
That's the number I found in the old post
-
jval
10:50:01 08/25/20
Re: Re: I found a part number in an old post
-
Potacka
21:20:42 08/25/20
Re: Source for the bearings?
-
ouikikazz
08:56:59 08/24/20
Are these the bushings you're looking for?
-
jval
14:40:38 08/24/20
Re: Are these the bushings you're looking for?
-
ouikikazz
09:00:21 08/25/20
Yeah I'm going to replace it once I figure out how to get it
-
jval
13:36:35 08/22/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.