Subject	Totally doable.
Posted by	ni[x]it on August 22, 2020 at 1:27 PM
	This message has been viewed 213 times.
In Reply To	Throttle Body/Linkage Dissasembly posted by jval on August 21, 2020 at 09:39 PM
Message	It separates in the middle. I don't recall exactly, but you need to drive a pin or two out if I recall correctly. It was not exactly fun, but it wasn't horrible either. For powder coating the throttle bodies, I left mine in and they just masked them off.
Follow Ups	Throttle Body/Linkage Dissasembly - jval 21:39:01 08/21/20 Totally doable. - ni[x]it 13:27:23 08/22/20 Powder coat guy wanted them off. - jval 13:37:46 08/22/20 Re: Throttle Body/Linkage Dissasembly - Kvert 13:29:45 08/22/20 Source for the bearings? (n/m) - ZXoltan 13:31:11 08/22/20 Re: Source for the bearings? - Kvert 14:00:23 08/22/20 I found a part number in an old post - jval 18:12:58 08/22/20 Re: I found a part number in an old post - Potacka 19:51:59 08/24/20 That's the number I found in the old post - jval 10:50:01 08/25/20 Re: Re: I found a part number in an old post - Potacka 21:20:42 08/25/20 Re: Source for the bearings? - ouikikazz 08:56:59 08/24/20 Are these the bushings you're looking for? - jval 14:40:38 08/24/20 Re: Are these the bushings you're looking for? - ouikikazz 09:00:21 08/25/20 Yeah I'm going to replace it once I figure out how to get it - jval 13:36:35 08/22/20
Post a Followup	You cannot reply to this message because you are not logged in.