Subject	Throttle Body/Linkage Dissasembly
Posted by	jval on August 21, 2020 at 9:39 PM
	This message has been viewed 423 times.
Message	Can anyone tell me if it's possible to remove this bracket for powder coating? If so, can you tell me how and where it separates? I've tried heat and cold. I have tried both methods to remove this bearing from the driver side throttle body as well, any clues on how to remove it?
Follow Ups	Throttle Body/Linkage Dissasembly - jval 21:39:01 08/21/20 Totally doable. - ni[x]it 13:27:23 08/22/20 Powder coat guy wanted them off. - jval 13:37:46 08/22/20 Re: Throttle Body/Linkage Dissasembly - Kvert 13:29:45 08/22/20 Source for the bearings? (n/m) - ZXoltan 13:31:11 08/22/20 Re: Source for the bearings? - Kvert 14:00:23 08/22/20 I found a part number in an old post - jval 18:12:58 08/22/20 Re: I found a part number in an old post - Potacka 19:51:59 08/24/20 That's the number I found in the old post - jval 10:50:01 08/25/20 Re: Re: I found a part number in an old post - Potacka 21:20:42 08/25/20 Re: Source for the bearings? - ouikikazz 08:56:59 08/24/20 Are these the bushings you're looking for? - jval 14:40:38 08/24/20 Re: Are these the bushings you're looking for? - ouikikazz 09:00:21 08/25/20 Yeah I'm going to replace it once I figure out how to get it - jval 13:36:35 08/22/20
Post a Followup	You cannot reply to this message because you are not logged in.