TwinTurbo.NET: Nissan 300ZX forum - Re: How clean are the fins for the radiator and for the AC
Subject
Re: How clean are the fins for the radiator and for the AC
Posted by
KA8
on August 19, 2020 at 7:34 PM
This message has been viewed
201
times.
In Reply To
How clean are the fins for the radiator and for the AC
posted by MixManMash
on August 19, 2020 at 07:29 PM
Message
Yup just did that. Used compressed air to blow out. Wasn't too dirty some leaves and pet hair were blown out. Now coolant is 50% water. I may add some water wetter.
Follow Ups
My Z ran little warm today... suggestions?
-
KA8
19:01:48 08/19/20
How clean are the fins for the radiator and for the AC
-
MixManMash
19:29:39 08/19/20
Re: How clean are the fins for the radiator and for the AC -
KA8
19:34:19 08/19/20
Fins are not all bent up? Usually, compressed air can
-
MixManMash
06:17:04 08/20/20
Add more water too while you're at it. Antifreeze is a poor
-
Barry (NJ)
16:46:28 08/24/20
A few things
-
Stanky (BC)
19:51:33 08/19/20
Got it! Thanks y'all
-
KA8
20:21:20 08/19/20
I'm not so sure on the cooler thermostat. Greg at SZ
-
MixManMash
06:02:55 08/20/20
Did you pressure check the system?
-
ZXoltan
06:54:03 08/21/20
Re: Did you pressure check the system?
-
KA8
09:54:49 08/21/20
Again, did you pressure check the system...
-
ZXoltan
13:42:23 08/21/20
Recently saw mention of a GKTech Fan blade, anyone know more
-
nissubaru
21:46:52 08/19/20
Interesting... Could be a bonus for those with cracked OEMs. (n/m)
-
KevinsFairlady
10:55:53 08/20/20
Make sure your aux fan is functional.
-
Doug71zt(CAN)
18:49:52 08/20/20
Re: Make sure your aux fan is functional.
-
KA8
09:57:58 08/21/20
Isn't the OEM gauge & sensor highly non-linear, with
-
black300zx
08:13:24 08/21/20
Exactly this. (n/m)
-
Barry(TN)
09:26:48 08/21/20
True. I'd hook up Datascan and actually measure coolant
-
MixManMash
12:46:38 08/21/20
How accurate is the gauge sensor/sender?
-
ZXoltan
15:36:25 08/21/20
Data scan reads the ECU sensor not the dash gauge sensor. (n/m)
-
itsa300zx
16:31:30 08/21/20
Makes sense. But how accurate is that sensor? (n/m)
-
ZXoltan
16:42:51 08/21/20
Considering the ECU makes decisions on that sensor, it's
-
MixManMash
17:33:07 08/21/20
Plenty. It reads in single digits. (n/m)
-
Bernie (NoVA)
23:24:30 08/23/20
Good to know. thank you sirs.
-
ZXoltan
10:24:46 08/24/20
Because the dash gauge is non linear. It displays an ok zone (n/m)
-
Bernie (NoVA)
13:45:22 08/24/20
I hacked mine with an Arduino uno for fun
-
black300zx
16:21:36 08/25/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.