TwinTurbo.NET: Nissan 300ZX forum - That is a lot of over hang. IIRC, when I had COZ
Subject
That is a lot of over hang. IIRC, when I had COZ
Posted by
itsa300zx
on July 13, 2020 at 7:53 PM
This message has been viewed
126
times.
In Reply To
How my pads looked with Z1 350z rotor brackets
posted by Schmeal (NV)
on July 09, 2020 at 12:33 PM
Message
brackets the pattern was more crescent shaped tapering off at the ends. with the central portion only about 3mm.
Follow Ups
question for those with 350z rotors with stock calipers
-
moxie (SF)
23:53:06 06/28/20
I ran this setup for a short time on my last Z
-
Ghoztt (MD)
07:14:17 06/29/20
Also using Hawk (HPS+) pads
-
megaDan
08:18:09 06/29/20
yeah the pad overhangs a bit on the top
-
moxie (SF)
12:25:24 06/29/20
What was the reason for removing the 350z calipers to begin
-
Ghoztt (MD)
12:44:42 06/29/20
well, I was going to sell the car
-
moxie (SF)
13:49:48 06/29/20
This is silly logic. Refinished all 4. Install the Brembos (n/m)
-
Bernie (NoVA)
14:03:06 06/29/20
:thumbsup: (n/m)
-
moxie (SF)
15:23:08 06/29/20
I've had this setup for years..
-
Stanky (BC)
16:17:42 06/29/20
^this was meant towards OP, not directly at your post :) (n/m)
-
Stanky (BC)
16:18:51 06/29/20
I was completely stock until I made my Hyundai brembo kit
-
BlackholeZ
10:25:10 06/29/20
I had relocation bracket before upgrading to brembos. In my
-
KA8
12:49:42 06/29/20
thank you, this is all I needed to hear! (n/m)
-
moxie (SF)
13:57:38 06/29/20
I have them with the RP 13" rear kit. I also run Hawk HPS+
-
Red Hawk (CO)
14:18:28 06/29/20
Interesting, I wonder why KA8 ^^ had a different experience
-
moxie (SF)
15:44:04 06/29/20
Re: Interesting, I wonder why KA8 ^^ had a different experience
-
KA8
17:15:02 06/29/20
As an added note, different pads made the kit work for me.
-
fantomZ(OH)
15:00:43 06/30/20
Thank you! This looks interesting.
-
moxie (SF)
16:43:51 06/30/20
Here is the comparison
-
itsa300zx
16:48:45 06/30/20
thanks! (n/m)
-
moxie (SF)
17:53:09 06/30/20
How my pads looked with Z1 350z rotor brackets
-
Schmeal (NV)
12:33:11 07/09/20
That is a lot of over hang. IIRC, when I had COZ -
itsa300zx
19:53:00 07/13/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.