TwinTurbo.NET: Nissan 300ZX forum - I have been using the pinch weld to lift for a few years
People Seeking Info
 
   


     
Subject I have been using the pinch weld to lift for a few years
     
Posted by Gordo LSZ Daytona on June 24, 2020 at 7:27 PM
  This message has been viewed 225 times.
     
In Reply To Unfortunately I use my quick jack on the Z far too often. posted by megaDan on June 24, 2020 at 03:24 PM
     
Message without incident. Rubber blocks, two per side. Keep the front block behind the front door jam / front fender gap to insure you don't bend up the bottom of the fender tabs. Otherwise never had an issue.

_________________________________________________


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.