TwinTurbo.NET: Nissan 300ZX forum - Re: Unfortunately I use my quick jack on the Z far too often.
Subject
Re: Unfortunately I use my quick jack on the Z far too often.
Posted by
PNW280Z
on June 24, 2020 at 5:56 PM
This message has been viewed
250
times.
In Reply To
Unfortunately I use my quick jack on the Z far too often.
posted by megaDan
on June 24, 2020 at 03:24 PM
Message
I think I understand. For the front portion, are you talking about the unibody portion that is perpendicular to the ground but starts to move upward towards the top of the fender well (right inside the pinch weld).
Follow Ups
Quik Jack Placement
-
PNW280Z
09:52:18 06/24/20
They sell pinch-weld blocks that have worked well for me
-
jval
13:35:23 06/24/20
Unfortunately I use my quick jack on the Z far too often.
-
megaDan
15:24:10 06/24/20
Re: Unfortunately I use my quick jack on the Z far too often. -
PNW280Z
17:56:49 06/24/20
I’ve only used mine once, I do the same (n/m)
-
itsa300zx
19:06:20 06/24/20
I have been using the pinch weld to lift for a few years
-
Gordo LSZ Daytona
19:27:02 06/24/20
Photos look deceiving....?
-
FrozTTy
18:52:39 06/25/20
The rubber is compressed by the pinch weld.
-
Gordo LSZ Daytona
20:19:12 06/25/20
Which model quick jack do you have? (n/m)
-
ctheobal
23:23:40 06/26/20
Which model quick jack do you have? (n/m)
-
ctheobal
14:24:55 07/04/20
Which model quick jack do you have? (n/m)
-
ctheobal
18:56:54 08/01/20
You can also try placing your QuickJack's Sideways
-
slick666
10:04:06 06/30/20
Post a
Followup
You cannot reply to this message because you are not
logged in
.