Subject	GTX2860 is a hard choice to beat for your goals.
Posted by	jmw300zx on June 10, 2020 at 5:40 PM
	This message has been viewed 238 times.
In Reply To	Need Guidance on Turbos posted by MJzTTZ on June 10, 2020 at 09:45 AM
Message	I used to have 530's and as long as you have all the breather mods, the spool between 530's and 2860's is very minimal but the ceiling is much higher on the GTX2860's. Either way pushing a stock block to 650 whp is likely a time bomb. You can stay conservative on low end torque and increase your odds of longevity but either way, 650whp is just pushing it without upgraded pistons and rods. Built engine, 2.5" IC piping, 2.5" intake piping, 3" exhaust, and GTX2860's will give you great response down low with the ability to make 750+ whp.
Follow Ups	Need Guidance on Turbos - MJzTTZ 09:45:26 06/10/20 You would be pushing the CZP G5 turbos too hard to reach - Ghoztt (MD) 11:29:06 06/10/20 Re: You would be pushing the CZP G5 turbos too hard to reach - MJzTTZ 11:45:27 06/10/20 That's a loaded question with many variables - Ghoztt (MD) 12:45:05 06/10/20 Re: That's a loaded question with many variables - MJzTTZ 13:03:39 06/10/20 Ask Greg or Seb at SpecialtyZ, that turbo is their - Ghoztt (MD) 13:15:08 06/10/20 GTX2860 is a hard choice to beat for your goals. - jmw300zx 17:40:26 06/10/20 Yup. I would recommend pistons and rods and valve springs - ForceFedTT 23:01:22 06/10/20 Thank you. I looked into GTX2860 and was just worried that - MJzTTZ 09:10:44 06/11/20 Look, if you're trying to keep stock internals given your - Ghoztt (MD) 11:38:02 06/11/20 The car sat for 8 years because I couldn't figure out how to - MJzTTZ 11:49:58 06/11/20 If the seals starting to leak on the turbos now larger - Ghoztt (MD) 12:14:54 06/11/20 Re: If the seals starting to leak on the turbos now larger - MJzTTZ 12:42:40 06/11/20 If it's running fine on stock injectors just run that until - Ghoztt (MD) 13:28:14 06/11/20
Post a Followup	You cannot reply to this message because you are not logged in.