Subject	Re: Saw your profile. 54mm. Did you like the quality of
Posted by	lleron on June 08, 2020 at 6:36 PM
	This message has been viewed 149 times.
In Reply To	Saw your profile. 54mm. Did you like the quality of posted by Mr.Stacy on June 07, 2020 at 12:25 PM
Message	Overall I was happy. The previous member that used to do them here machined the throttle shafts quite a bit more, but overall the work was clean. I can try to take a picture at some point soon.
Follow Ups	throttle body upgrade options - if any? - DanThomas 20:55:22 06/04/20 you can always "hourglass" OR one side the shaft for free - Zvil (FL) 05:23:23 06/05/20 Dont bother honestly - Stanky (BC) 07:50:21 06/05/20 Re: Dont bother honestly - RBS145 09:08:52 06/05/20 I'd say a lot of it was likely from fixing boost leaks. (n/m) - MixManMash 11:30:37 06/05/20 I thought the same thing (n/m) - RICH1 11:58:38 06/05/20 I'm on the "save it for last" bandwagon myself - Zvil (FL) 21:42:20 06/05/20 I recently had maxbore modify my stock TBs. - lleron 10:17:59 06/05/20 What diameter were they able to bore the stock TBs? (n/m) - Mr.Stacy 18:08:37 06/06/20 Saw your profile. 54mm. Did you like the quality of - Mr.Stacy 12:25:02 06/07/20 Re: Saw your profile. 54mm. Did you like the quality of - lleron 18:36:59 06/08/20 Pictures of Maxbore's work: - lleron 20:08:39 06/11/20 I was recommended by Specialty Z to upgrade if possible. - platinumist 11:42:12 06/05/20 Or go with full stand alone and setup dual DBW throttle - MixManMash 12:35:32 06/05/20 Sounds like a dream, I hate our cars idle control system. - platinumist 13:38:22 06/05/20
Post a Followup	You cannot reply to this message because you are not logged in.