TwinTurbo.NET: Nissan 300ZX forum - I wouldn't coat a precision surface like upper to
People Seeking Info
 
   


     
Subject I wouldn't coat a precision surface like upper to
     
Posted by ConVerTT on June 01, 2020 at 5:49 PM
  This message has been viewed 119 times.
     
In Reply To I thought coating any surface that would seal is a no-no? posted by fuzzymonkey on June 01, 2020 at 03:47 PM
     
Message lower plenum or the mating surface on the balance tube, but I've done (or had some else do) water pipes, intercooler pipes, fuel hardlines many times without issue.

FYI just pulled the oil pan and the mating surface between the block and oil pan is painted

ConVerTT - 93 Hi Compression TT Convertible (black)
XtraVerTT - 93 Hi Compression TT Convertible (glacier white)
SlickTTop - 96 OBD1 TT Slicktop (black)
Old Yeller - 90 Slicktop NA (PGY)
RedZed - 90 "factory" 2+0 TT
EmoZed - 89 RHD for parts - RIP

And their hot Asian Cousin - 01 Acura NSX NA

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.