TwinTurbo.NET: Nissan 300ZX forum - Very nice, it was a good weekend for Z work
People Seeking Info
 
   


     
Subject Very nice, it was a good weekend for Z work
     
Posted by BlackholeZ on May 03, 2020 at 9:27 PM
  This message has been viewed 192 times.
     
In Reply To Getting a little bit of work done... posted by Woodnutz on May 03, 2020 at 04:19 PM
     
Message I installed some Gofastbits Recircs and Greddy Profec EBC this weekend, and in the process found a inlet pipe that the worm gear clamp had popped on, cleaned the filters and mafs, and replaced all the vacuum lines. Old BAE is much happier now

-Dan


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.